Hi
I have developed a BPM which collects a few IDocs with a correlation based on the message content.
When triggering the BPM in Development, everything works as intended. (Messages are collected together based on the value of the correlation)
After this we decided to transport the BPM to Test by using NWDI. The deployment was successful, but when we try to run the scenario, the message gets delivered successfully in the monitor, but no BPM process is being triggered.
Audit log in monitor:
I've tried the same with the BPM in Dev but there it works fine, when trying in Test or Production, the BPM isn't getting triggered. Same when trying to trigger the process through the WS Navigator or SoapUI.
The endpoint url we use is always the: http://host:port/MessagingSystem/receive/JPR/XI
I can see the process in the process repository (but due to a conditional start, I cannot start it from there with a test).
Do you have any suggestions on how to troubleshoot this?
I can see nothing in the NWA Logs / Developer Traces either.
Our system is a PO 7.40 SP5.
Thanks in advance.
Best regards,
Nicolas